Materials for electric motor plants

Electric motors are very often used in large industrial enterprises. They are considered one of the cheapest, but at the same time they are of high quality and efficiency. However, sometimes such a device fails, which stops the entire production process. The best solution is to return the engine to the factory that repairs such machines. We advise which materials are necessary for professional repair of the electric motor.

The most important elements of the overhaul of the electric motor
The whole process of repairing or overhauling an electric motor is called rewinding. Its main purpose is the regeneration of individual parts of the device. It is worth knowing that in engines of this type, both mechanical elements and electronics can be damaged. In the first case, professionals often struggle with the weakening of the shaft neck or the wear of the bearing plate seat. As for the electrical parts, they are mostly broken terminals or broken cables.
Repairing an electric motor is an extremely complex process and can sometimes take up to 2 weeks. Nevertheless, rewinding and complex diagnostics bring the expected results and profit to the user very quickly.

It is important to note that repair companies subject the engine to detailed measurements before, as well as during and after disassembly of its components. This allows you to detect all defects, even invisible to the naked eye, as well as monitor the effectiveness of repairs. The measurements primarily include the resistance of the windings, housing components and the entire rotor package.

What materials are most needed by companies engaged in the repair of electric motors?
Repair companies, of course, should be equipped with professional measuring and mechanical tools, but profiles and winding wire deserve special attention. These products are widely used in the repair of electric motors, as they are characterized by high thermal properties, as well as resistance to harmful chemical factors. Winding wires are most often made of copper or aluminum. Their cross-section is round or profiled, and the surface is covered with polyester enamel. The top layer must be removed before connecting the wire to the perimeter. Of course, this does not apply to wires and profiles that are not covered with a protective substance. These products are usually used to create new windings not only in motors, but also in transformers or welding equipment. sensual bodyrub