Benelli Kite

Sight Adjustments

Clockwise down.
Clockwise right.
1 click = 1mm at 10m.

Rear Sight Aperture

Adjust the screw: turning towards (+) increases the width of the sight: turning towards (–) decreases the width of the sight.

Trigger Adjustments

First Stage Travel To decrease travel turn the screw (A) clockwise. Trigger Support Turn the screw (B) clockwise to move the trigger support backwards. After this has been done, check the “first phase” travel, and adjust screw (A) again if necessary.
Trigger Shoe Loosen screw (C) to move the trigger shoe lengthwise or incline it sideways (20° right or left). Loosen screw (D) to rotate the trigger to the right or to the left.
First Stage Weight To increase weight, turn screw (E) clockwise.
Trigger Stop Turn screw (F) to adjust trigger stop. N.B. Do not tighten too much: the shot will not fire!
Carry out the adjustments mentioned below after removing the pistol grip. Second Stage Travel To decrease travel turn screw (G) clockwise. WARNING: do not over-tighten: the release will not cock. Second Stage Weight To increase weight, turn screw (H) clockwise.
Dry Firing With the pistol cocked adjust the firing pin stop lever as shown in the illustration. To cancel the dry firing, always adjust the pistol when cocked.

Velocity Adjustment

The pistol is set at the factory with a pellet velocity of approx. 145 m/s. To increase pellet velocity turn screw (K) clockwise. This adjustment is only advised if using a chronograph. This operation can vary the regulation of the trigger pull weight. It is advisable to check weight once again after adjustment.