HAMMERLI FP10

Sight Adjustments

Elevation: Screw #1 (front left on sight block). Clockwise down.
Windage: Screw #2 (rear left on sight block). Clockwise right.
1 click = 10mm @ 50m.
Rear sight notch width can be adjusted by turning screw #3 (clockwise to widen).

Trigger Adjustments

Weight Turn screw 1 clockwise to increase.
Two Stage Trigger The trigger slack spring (1231) must be fitted for the two stage trigger. Turn screw 2 clockwise to increase first stage weight.
Trigger Slack Turn screw 1093 anticlockwise to increase trigger slack (only applicable if trigger slack spring 1231 is fitted).

Stabilizer: This can be adjusted by angle (loosen screws 1226, adjust and retighten) and weights may be positioned with set screws 1072.

Conpensator: This should be periodically cleaned (suggested every 2500 rounds). Remove by releasing the two set screws 1003. Front sight base must first be removed to gain access to front screw 1003.

Grip Angle Adjustment: The grip can be adjusted in two places:
Release grip plate screw 1111, set the required angle and retighten screw.
The angle of the grip can be displaced about the axis by turning the grip angle side adjusting screws on the right and left sides of the frame in or out.