STEYR LP 1 LATE MODEL
Sight Adjustments
Clockwise down (left hand knob).
Clockwise left (right hand knob).
1 click = 1.2mm @ 10m.
Rear Sight Width/Depth
See diagram below. Turn screw on right hand side clockwise or left hand anti-clockwise to increase sight aperture width, opposite to decrease. Adjustment is 0-7.0mm.
Depth may be adjusted by loosening screws (#8 in diagram) and positioning cover plate to desired position before retightening. Adjustment is 1.5-3.2mm.
Trigger Stop
1st vertical screw behind trigger (I).
1st Stage Weight
2nd vertical screw behind trigger (II).
1st Stage Travel
Before adjusting loosen trigger stop screw a few turns (I). 3rd vertical screw behind trigger (III). Readjust trigger stop when finished.
2nd Stage Weight
Remove grip. 4th vertical screw behind trigger (IV).
Sear Engagement
5th screw behind trigger (V). Manual recommends that this screw NOT be changed from factory setting.
Grip Adjustment
The grip is adjustable and pivotable to the frame in all directions to suit many different hand shapes and positions. To achieve this grip must first be removed.
Adjustment is made by means of six countersunk allen screws in the bottom and rear of the receiver housing. When adjusting these screws only move in 1/4 of a turn increments before replacing grip to see if enough adjustment has been made.
Regulating Pellet Velocity
Remove the grip.
Turn slotted screw in rear of receiver housing clockwise to increase velocity, anti-clockwise to decrease.
